Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Liu, W.; Podowski, M. Z.*
Nihon Kikai Gakkai Netsu Kogaku Konfarensu 2016 Koen Rombunshu (USB Flash Drive), 2 Pages, 2016/10
Prediction of Critical Heat Flux (CHF) is important for nuclear reactor safety. However, the CHF prediction for subcooled flow boiling in complicated geometry such as fuel assembly still remains unsolved. As the first step for the CHF prediction in rod bundles, in this paper, we tried to predict the CHF in annulus, which is the most basic flow geometry simplified from a fuel bundle. We performed the CHF prediction by using liquid sublayer dryout model, combining with ANSYS CFX code to get the single phase velocity distribution inside the annulus. The results show that the CHF in annulus can be predicted in an accuracy of about 
20%.
Liu, W.; Podowski, M. Z.*
Nihon Kikai Gakkai Netsu Kogaku Konfarensu 2015 Koen Rombunshu (CD-ROM), 2 Pages, 2015/10
This paper gives prediction to the transient heat transfer at Departure of Nucleate Boiling (DNB) point for subcooled flow boiling. The prediction is carried out by solving the heat conduction equations in cylindrical coordinates with convective boundary condition, which changes with the change of the heat transfer mode on the heated surface. DNB is assumed to happen at the complete dryout of liquid sublayer trapped between the heated wall and an elongated vapor clot, during the passing time of the vapor clot. Important parameters including initial thickness of the liquid sublayer, vapor clot length, vapor clot velocity and void fraction etc., are calculated from the Liu - Nariai model. The initial heater surface temperature is derived from the Jens-Lottes correlation. The transient changes of liquid sublayer thickness, surface temperature at DNB are reported. No obvious temperature jumping is observed at DNB. To predict temperate excursion at Critical Heat Flux (CHF), more simulations to the transient boiling and film boiling processes are needed.
Ezato, Koichiro; Suzuki, Satoshi; Dairaku, Masayuki; Akiba, Masato
Fusion Engineering and Design, 81(1-7), p.347 - 354, 2006/02
Times Cited Count：12 Percentile：63.1(Nuclear Science & Technology)no abstracts in English
Ezato, Koichiro; Suzuki, Satoshi; Dairaku, Masayuki; Akiba, Masato
Fusion Engineering and Design, 75-79, p.313 - 318, 2005/11
Times Cited Count：10 Percentile：56.74(Nuclear Science & Technology)no abstracts in English
Shibamoto, Yasuteru; Yonomoto, Taisuke; Nakamura, Hideo; Nishikizawa, Tomotoshi
Proceedings of 4th Japan-Korea Symposium on Nuclear Thermal Hydraulics and Safety (NTHAS-4), p.210 - 214, 2004/11
no abstracts in English
Araya, Fumimasa; Nakatsuka, Toru; Yoritsune, Tsutomu; Kureta, Masatoshi; Yoshida, Hiroyuki; Ishikawa, Nobuyuki; Sato, Takashi; Watanabe, Hironori; Okubo, Tsutomu; Iwamura, Takamichi; et al.
JAERI-Research 2002-018, 37 Pages, 2002/10
JAERI-Research-2002-018.pdf:2.62MB
no abstracts in English
Iwamura, Takamichi; Okubo, Tsutomu; Kureta, Masatoshi; Nakatsuka, Toru; Takeda, Renzo*; Yamamoto, Kazuhiko*
Proceedings of 13th Pacific Basin Nuclear Conference (PBNC 2002) (CD-ROM), 7 Pages, 2002/10
In order to ensure sustainable energy supply in Japan, the reduced-moderation water reactor (RMWR) has been developed by JAERI since 1998. MOX fuel assemblies with tight lattice arrangement are used to increase the conversion ratio. In order to establish negative void reactivity coefficient, the core should be short and flat to increase neutron leakage from the core. The core designs were accomplished to a large core with 1,356MWe and a small core with 330MWe. For both cores, negative void coefficient and natural circulation cooling of the core were realized. To confirm thermal-hydraulic feasibility, critical heat flux experiments were performed using 7-rod bundles with the gap width of 1mm and 1.3mm. The results indicated that enough cooling was assured for the tight lattice core. Further R&D studies, including large scale thermal-hydraulic experiments, reactor physics experiments, development of high burn-up fuel cladding material and simplified reprocessing technology, are necessary to realize commercial introduction of RMWR by 2020's for the replacement of current generation LWRs.
Iguchi, Tadashi; Iwaki, Chikako*; Anoda, Yoshinari
JAERI-Research 2001-060, 91 Pages, 2002/02
JAERI-Research-2001-060.pdf:6.34MB
no abstracts in English
Sato, Kazuyoshi; Ezato, Koichiro; Taniguchi, Masaki; Suzuki, Satoshi; Akiba, Masato
Journal of Plasma and Fusion Research SERIES, Vol.5, p.556 - 560, 2002/00
no abstracts in English
Iguchi, Tadashi; Ito, Hideo; Kiuchi, Toshio; Watanabe, Hironori; Kimura, Mamoru*; Anoda, Yoshinari
JAERI-Data/Code 2001-013, 502 Pages, 2001/03
JAERI-Data-Code-2001-013.pdf:32.38MB
no abstracts in English
Kaminaga, Masanori; Kinoshita, Hidetaka; Haga, Katsuhiro; Hino, Ryutaro; Sudo, Yukio
Proceedings of International Workshop on Current Status and Future Directions in Boiling Heat Transfer and Two-Phase Flow, p.135 - 141, 2000/00
no abstracts in English
J.Boscary*; Araki, Masanori; J.Schlosser*; Akiba, Masato; F.Escorbiac*
Fusion Engineering and Design, 43(2), p.147 - 171, 1998/00
Times Cited Count：43 Percentile：93.87(Nuclear Science & Technology)no abstracts in English
L.Zheng*; Iguchi, Tadashi; Kureta, Masatoshi; Akimoto, Hajime
JAERI-Research 97-054, 85 Pages, 1997/08
JAERI-Research-97-054.pdf:2.18MB
no abstracts in English
Iguchi, Tadashi; Onuki, Akira; Iwaki, Chikako*; Kureta, Masatoshi; Akimoto, Hajime
Proc. of 5th Int. Conf. on Nuclear Engineering (ICONE-5), p.1 - 9, 1997/00
no abstracts in English
JAERI-Data/Code 96-004, 109 Pages, 1996/02
JAERI-Data-Code-96-004.pdf:2.3MB
no abstracts in English
Guo, Z.*; Kumamaru, Hiroshige; Kukita, Yutaka
JAERI-M 93-238, 20 Pages, 1993/12
no abstracts in English
Iwamura, Takamichi; Watanabe, Hironori; Okubo, Tsutomu; Araya, Fumimasa; Murao, Yoshio
Journal of Nuclear Science and Technology, 30(5), p.413 - 424, 1993/05
Times Cited Count：2 Percentile：29.79(Nuclear Science & Technology)no abstracts in English
Iwamura, Takamichi; Watanabe, Hironori; Araya, Fumimasa; Okubo, Tsutomu; Murao, Yoshio
JAERI-M 92-050, 46 Pages, 1992/03
no abstracts in English
Iwamura, Takamichi; Watanabe, Hironori; Okubo, Tsutomu; Araya, Fumimasa; Murao, Yoshio
JAERI-M 92-033, 66 Pages, 1992/03
no abstracts in English
Iwamura, Takamichi; Okubo, Tsutomu; Araya, Fumimasa; Murao, Yoshio
Subchannel Analysis in Nuclear Reactors, p.281 - 301, 1992/00
no abstracts in English
